Agmaster® PTO Driveshaft AGM 4 560 mm 32x76 - 8372852

Product number: 8372852

AGM4 SD25 560 358340 351000


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.


Agmaster drive shaft with connection forks

Product advantages

Excellent price value
100% compatible with the Walterscheid standard clutch range
Easy quick-disconnect ASGE system at both ends
Lemon tubes
The scope of delivery includes a complete drive shaft size AGM560 with connection forks (profile 1 3/8" (6)), guard, retaining chain(s), operating and assembly instructions incl. declaration of conformity.
The standard design is suitable for the use of drive shafts with parallel axes. Depending on the application, it is recommended that a simple joint can be operated up to an angle of max. 25°. A constant angle during continuous operation of max. 15° should not be exceeded.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
Size
AGM4
Shaft length (Lz)
560 mm
Cross
32x76

ass: 14 sim: 0 croo: 0