Walterscheid® PTO Driveshaft with one-sided wide angle joint WWE 2280 - 1800106

Product number: 1800106

WWE 2280 STF15Z 1210 209109 200113 0VGA/1K ***


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.


Standard drive shaft with wide-angle joint on one side without connecting forks

Product advantages

The W series PTO drive shaft offers tried-and-tested Walterscheid technology and is perfectly designed to suit all application areas. The excellent benefits of this Walterscheid PTO drive shaft is a long service life, ease of use, and great safety properties. For decades, Walterscheid has been a guarantee of the highest quality. The W series are optimally dimensioned for drivetrain tasks, from simple to complex ones. It impresses users with its robust design and high reliability for daily use. Another advantage: All of the components in the PTO drive shaft W series can be replaced really easily to increase ease of use or if spare parts are needed.
The scope of delivery includes a complete drive shaft size WWE 2280 with guard, retaining chain(s), operating and assembly instructions incl. declaration of conformity.
Connection forks are not included in the scope of delivery and must be purchased separately. Furthermore, a wide-angle cross kit must be ordered additionally for this version.
This design is suitable for non-axis-parallel use when the simple universal joint is mainly in the extended position and the wide-angle joint is to be angled. Depending on the application, it is recommended that the wide angle joint can be operated up to a maximum angle of 80°. A constant angle during continuous operation of max. 20° should not be exceeded.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
Type
WWE
Size
2280
Shaft length (Lz)
1210
Item no. attachment WH-I
607006
Torque of clutch in daNm
0
Rotation speed max. RPM
1000 UPM
Length of guard tube (inner)
755
Nipple form / position I/A
-Z LB
SNR cone WH-A
365344
Cone type WH-I
WW80
SNR cone WH-I
134399
Cone Type WH-A
RP4
Outer profile length
1005
Length of guard tube (outer)
955
Protective colour
Yellow
Chain WH-A
K
Inner profile length
1020
Attachment type of profile
AA
Cross seal
STANDARD
Abbreviation attachment WH-I
DOPG
Profile tube - outer type
1K
Profile tube - inner type
0VGA
Guard type
STF15Z

ass: 10 sim: 0 croo: 0