Walterscheid® PTO Driveshaft W 2400 - 1113130

Product number: 1113130

W 2400 SD25Z 1210 350113 350113 S4LH/S5 ***


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.


The listing of this OEM article is for the purpose of identification only. It is not intended as a spare part until further notice!

Discontinued Model. Limited availability. Successor product: 1800086

Product advantages

The W series PTO drive shaft offers tried-and-tested Walterscheid technology and is perfectly designed to suit all application areas. The excellent benefits of this Walterscheid PTO drive shaft is a long service life, ease of use, and great safety properties. For decades, Walterscheid has been a guarantee of the highest quality. The W series are optimally dimensioned for drivetrain tasks, from simple to complex ones. It impresses users with its robust design and high reliability for daily use. Another advantage: All of the components in the PTO drive shaft W series can be replaced really easily to increase ease of use or if spare parts are needed.
The standard design is suitable for the use of drive shafts with parallel axes. Depending on the application, it is recommended that a simple joint can be operated up to an angle of max. 25°. A constant angle during continuous operation of max. 15° should not be exceeded.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
Type
W
Size
2400
Shaft length (Lz)
1210
Item no. attachment WH-A
134770
Item no. attachment WH-I
134770
Torque of clutch in daNm
0
Rotation speed max. RPM
1000 UPM
Length of guard tube (inner)
795
Chain WH-I
K
Chain WH-A
K
Inner profile length
1085
Attachment type of profile
AA
Length of guard tube (outer)
995
SNR cone WH-A
199175
Cone type WH-I
RP6
Cone Type WH-A
RP6
Protective colour
Yellow
Outer profile length
1065
Nipple form / position I/A
LB LB
SNR cone WH-I
199175
Cross seal
STANDARD
Abbreviation attachment WH-A
ZK
Abbreviation attachment WH-I
ZK
Profile tube - outer type
S5
Profile tube - inner type
S4LH
Guard type
SD25Z

ass: 9 sim: 0 croo: 0