Walterscheid® PTO Driveshaft W 2100 - 1113120

Product number: 1113120

W 2100 SD05 1210 1002100 1002100 00CH/0A ***


Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.


Standard drive shaft without connection forks

Product advantages

The W series PTO drive shaft offers tried-and-tested Walterscheid technology and is perfectly designed to suit all application areas. The excellent benefits of this Walterscheid PTO drive shaft is a long service life, ease of use, and great safety properties. For decades, Walterscheid has been a guarantee of the highest quality. The W series are optimally dimensioned for drivetrain tasks, from simple to complex ones. It impresses users with its robust design and high reliability for daily use. Another advantage: All of the components in the PTO drive shaft W series can be replaced really easily to increase ease of use or if spare parts are needed.
The scope of delivery includes a complete drive shaft size W2100 with guard, retaining chain(s), operating and assembly instructions incl. declaration of conformity.
Connection forks are not included in the scope of delivery and must be purchased separately.
The standard design is suitable for the use of drive shafts with parallel axes. Depending on the application, it is recommended that a simple joint can be operated up to an angle of max. 25°. A constant angle during continuous operation of max. 15° should not be exceeded.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
Type
W
Size
2100
Shaft length (Lz)
1210
Item no. attachment WH-A
139472
Item no. attachment WH-I
139472
Torque of clutch in daNm
0
Rotation speed max. RPM
1000 UPM
SNR cone WH-I
153115
Nipple form / position I/A
LB LB
SNR cone WH-A
153115
Cone Type WH-A
RP5
Cone type WH-I
RP5
Length of guard tube (outer)
1055
Inner profile length
1115
Attachment type of profile
AA
Protective colour
Yellow
Length of guard tube (inner)
1055
Outer profile length
1105
Chain WH-A
K
Chain WH-I
K
Cross seal
STANDARD
Abbreviation attachment WH-A
ZK
Abbreviation attachment WH-I
ZK
Profile tube - outer type
0A
Profile tube - inner type
00CH
Guard type
SD05

ass: 10 sim: 0 croo: 0