Deutsch
English
Français
Walterscheid® Fitting tool SW 42 - 1697002
SW42 Fitting tool
Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.
The scope of delivery includes 1x Assembly tool SW42 (lower picture).
If required, a hydraulic power unit can also be ordered (order number: 1697016).
If required, a hydraulic power unit can also be ordered (order number: 1697016).
Suitable for torque testing of overload clutches up to 5000 Nm.
Overload clutches with a higher torque can be tested by us in the factory. Please send us a specific request for this.
Overload clutches with a higher torque can be tested by us in the factory. Please send us a specific request for this.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
- Manufacturer
- Walterscheid
- Torque
- max. 5000 Nm
- Length (mm)
- 700
- Height (mm)
- 600
- Width (mm)
- 600
