Walterscheid® wide angle joint WG 2480 - 1113307

Product number: 1113307

WG 2480 351010 3514174 LL+66 ***

Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.

Wide-angle joint for drive shaft series WW

Product advantages

The W series joint offers proven Walterscheid technology and is optimally designed for all areas of application. Excellent power transmission, long service life, low maintenance, convenient operation. For decades, Walterscheid has been a guarantor of top quality. The W series is optimally dimensioned for simple to heavy drive tasks. It is characterized by its robust design and high reliability in daily use. Another advantage: All components of the W series drive shafts can be easily replaced to increase operating comfort or in the case of spare parts.

Walterscheid Identification guide for driveshafts

Repair instructions joint

Repair instructions wide angle joint (80 degrees)

Assembly of wide angle joints (neutral language)

The scope of delivery includes a complete WG2480 joint with 1⅜‘‘ (6) connection profile.

Depending on the application, it is recommended that the wide angle joint can be operated up to a maximum angle of 80°. A constant angle during continuous operation of max. 20° should not be exceeded.

All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.