Deutsch
English
Français
Walterscheid® Safety guard half inner PGH 20 - 1116289
PGH20 J1000 8627603 TR=SW-HT
Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.
Inner safety guard half for PowerDrive drive shaft size P300 | P400 | P500
Product advantages
The PowerDrive driveshaft with single joints can be combined with a full guard. It eliminates the need for the guard pot on the equipment side and both retaining chains, and the dangerous rotation of the complete guard is prevented. For easy handling of the PowerDrive PTO shaft, the guard funnels can be easily unlocked and pushed back. The resulting free space makes it much easier to connect and disconnect the PTO shafts and to maintain the joints and guard bearings.
Product advantages
The PowerDrive driveshaft with single joints can be combined with a full guard. It eliminates the need for the guard pot on the equipment side and both retaining chains, and the dangerous rotation of the complete guard is prevented. For easy handling of the PowerDrive PTO shaft, the guard funnels can be easily unlocked and pushed back. The resulting free space makes it much easier to connect and disconnect the PTO shafts and to maintain the joints and guard bearings.
The scope of delivery includes a complete Walterscheid protective half consisting of 1x protective tube half, 1x full protection funnel, 1x sliding ring and 1x retaining chain.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
- Type
- PGH
- Size
- 20
- Manufacturer
- Walterscheid
- L (mm)
- 1000
- D (mm)
- 200
- Drawing
- 86.201
