Deutsch
English
Français
Walterscheid® Safety guard SD 15 - 1368647
SD15 A550 J550 851506 K 851506 K***
Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.
Safety guard for standard drive shaft size W2100 | W2200 | W2300
Product advantages
The SD guard complies with worldwide safety regulations and takes into account additional radial loads during test requirements according to ISO 5674 and France Decree 81293. A guard funnel with support ring and retaining chains prevents the guard tubes from spinning.
Product advantages
The SD guard complies with worldwide safety regulations and takes into account additional radial loads during test requirements according to ISO 5674 and France Decree 81293. A guard funnel with support ring and retaining chains prevents the guard tubes from spinning.
The scope of delivery includes a complete Walterscheid drive shaft guard consisting of 1x inner guard half and 1x outer guard half.
All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.
- Type
- SD
- Size
- 15
- Manufacturer
- Walterscheid
- L (mm)
- 550
- D (mm)
- 158
- n
- 6
- Drawing
- 85.103
