Walterscheid® Friction clutch K 90/4T - 1156166

Product number: 1156166

K90/4T 2400 ZNP1 3/4-20 CC 160TOL

Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.

The listing of this OEM article is for the purpose of identification only. It is not intended as a spare part until further notice!

Discontinued Model. Limited availability. Successor product: 1604516

Product advantages

No power transmission interruption
Covers peak loads for a short time
Torque is maintained
2 directions of rotation (clockwise and anti-clockwise)
Adjustable
Suitable as a centrifugal coupling

The scope of delivery includes a complete friction clutch K96/4.

Friction clutches must be released after each long period of inactivity. In the released state, the clutch must be turned so that any stuck friction linings are released from the mating surfaces.
Since the friction linings are permanently pressed on by the springs, they can stick to the drivers. Before the season, the friction clutches should be released to regain the set torque and thus ensure machine protection. To release, tighten the release screws evenly until the spring assembly is loose. Then start up the PTO shaft so that the individual linings loosen. Finally, loosen the screws again. You have to be even more careful if the coil springs are not clamped in a package but individually. Because each spring has its own preload here, you need to make some notes when you start airing or disassembling. Number each spring and then use a caliper gauge to determine its length. Only then, back off the nuts to vent until the springs are free. After turning the hub, the springs must be preloaded back to the original dimension (the old length). Follow your notes exactly.

All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.