Walterscheid® Mounting Kit 303-12-6 – 8005474

Product number: 8005474

ZWS303

Similar to illustration. Use products only for their intended use. Content is subject to change without notice. Further sizes and combinations may be available: contact us for availability.
Cross references, designation of type by vehicle manufacturers or competitors are for guidance only.
Check that the part is correct for the application before fitting.

Original Walterscheid PTO guard repair kit

Product advantages

The Walterscheid diamond has been a guarantee of quality and safety for decades.
You can rely on their good reputation. It meets your requirements.

The scope of delivery includes 1x Mounting kit 303-12-6.

On many models of type-approved towing frames, type plates are riveted onto the rotatable PTO master shield. In these cases, a replacement requires the operator to present an affirmation in lieu of an oath (respective form enclosed in assembly instructions) which confirms that the respective towing frame is in use and the PTO spare part kit will only be attached to this towing frame. Furthermore, it has to be confirmed that the original type plate will be attached to the new PTO master shield in the same place. For this purpose, the enclosed rivets shall be used. Please also see the assembly and operation instructions of the towing frame. In case of the original type plate being lost, a replacement type plate has to be mounted. For this purpose, please contact Walterscheid GmbH. Contact can be established via our service partner in Dingelstädt, OHP Services Germany GmbH.

All components are designed specifically for the device and performance and it is not allowed to exchange for components other than those prescribed by Walterscheid. Damaged or missing parts can only replace with original Walterscheid parts and retrofit them in accordance with regulations and after consultation with Walterscheid.
The assignment, assembly and use of this model requires a detailed preliminary examination by qualified personnel. It is imperative to check the existing facilities and all of the machinery and equipment for their suitability for attachment. In particular, the characteristic values (e.g. vertical and pulling loads or torques) and the geometries (e.g. dimensions, screw hole patterns, free spaces) must be observed. Depending on the existing equipment of the machine, this can result in the use or purchase of additional components. The content of operating instructions must be observed.